The working steps of the panel table saw

The working steps of the panel table saw mainly include the following aspects:

1、 Preparation work

Cleaning the work area: Ensure that the work area is spacious and bright, and clean up debris to ensure safety and ease of operation.

Check the panel table saw:

Check whether the blade is sharp, intact, and ensure that the size of the saw blade is in a straight line.

Adjust the height of the panel table saw to adapt to the workpiece to be cut.

Test the machine for about 1 minute to check if it is running properly and ensure that the saw blade rotates in the correct direction.

Preparation of materials: Place the wood to be cut on the worktable of the panel table saw and ensure that the wood is kept at a certain distance from the blade to prevent danger. At the same time, prepare the necessary cutting materials such as wooden strips.

2、 Cutting operation

Adjust the gear size: Adjust the gear size of the panel table saw according to the cutting requirements.

Grip the wood tightly: Grip the wood tightly and use the handle of the panel table saw to panel it towards the blade, ensuring a smooth cutting motion.

Maintain speed and force: While paneling the wood, maintain a certain speed and force to ensure that the cutting line is straight and neat.

Plate receiving: When the plate is cut to a certain length (such as about 50mm), the receiving personnel start to manually receive it, keeping the plate moving until the cutting is completed.

3、 Cutting completion and subsequent work

Check cutting quality: After cutting is completed, release the handle, stop paneling the wood, and inspect the cut wood to ensure that the cutting line is clean and free of burrs.

Turn off power: After completing the cutting task, promptly turn off the power of the panel table saw.

Cleaning the work area: Clean the saw table and its surroundings, and remove any remaining materials.

4、 Precautions

Safety protection: Before operating the table saw, it is necessary to wear personal protective equipment, including safety goggles, masks, etc. Long hair must be rolled up, with sleeves rolled up above the elbows or buttoned tightly. Loose clothing is strictly prohibited, and gloves cannot be worn.

Avoid accidental injury: Do not place fingers or other body parts near the blade to prevent accidental injury. When cutting smaller pieces of wood, a panel rod or other safety tool should be used to keep hands far enough from the blade.

Focused operation: During the cutting process, be attentive and careful, and do not be distracted by other things.

Exception handling: When encountering wood blockage during the cutting process, stop paneling the wood first, then check if there is any obstruction in the cutting area, and remove it if necessary. When encountering hard wood, the cutting speed and strength can be adjusted.

By following the above steps, the cutting work of the panel table saw can be ensured to proceed smoothly, while also ensuring the safety of the operators.