How To Install The Tools Of Cnc Router Quickly

first, clean the tapping chuck. can use gasoline or something to cleaned. There are many gaps on the chuck. Before each tool is clamped, the residue in the chuck gap should be checked and removed.

Ensure the conical surface of chuck have a plate contact. The chuck is in contact with the conical hole of the shaft end by rubbing the shaft, and the contact is not good, and it is not easy to wear.

 Place the original pressure cap of the chuck and the pressure cap to capture the clamping jaws, and the sandwich part of the pressure cap to be recessed into the chuck groove, grasp the chuck evenly in the arrow direction, and the chuck grasps the cap;

The chuck and the pressure cap are installed on the spindle of the machine tool. Clean the cylindrical shank of the tool and put it into the holding hole. After confirming that the chuck and the tool are aligned, screw the pressure cap in place by hand. Then use a wrench to tighten the pressure cap evenly and firmly until the tool is firmly clamped before use

When loosening the knife, use the wrench to turn the pressure cap in the opposite direction. If you need to change the chuck, loosen the pressure cap to bring out the chuck and the tool, remove the tool, push the chuck forcefully in the direction of the arrow to push it out, and then replace it as needed Chuck with other apertures is fine