Table Saw----a Technical Job

Woodworking is a technical job, with many professional skills and key points of construction. Many woodworkers need to use a table saw when doing construction, so how can a woodworking table saw 45 bevel the edge? What should I pay attention to when woodworking sliding table saws? Let Kaise give you a detailed introduction below.

1. How to bevel the edge of woodworking table saw 45

If the woodworking table saw needs to be based on the 45 bevel, you can mark it on the board, and then follow the mark. You can also use a triangle ruler to make a 45-degree bevel on the table saw, and then erect the plank, and then start tapping. There are also table saws that can adjust the angle. Just adjust the table saw directly to a 45-degree angle. If the table saw cannot be adjusted, just put a 45-degree base plate underneath.

Second, what should be paid attention to when woodworking sliding table saw

1. Before the woodworker pushes the table saw, be sure to clean the table saw and the table surface. You should check whether the saw blades of the table saw are sharp, whether the saw blades are in the same straight line, and whether the rotation direction of the saw blades is correct.

2. When woodworkers push the table saw, they must not wear gloves, wear long clothes, or wear long hair, but they must wear a mask.

3. When the woodworker pushes the table saw, he can't directly take things around the saw blade by hand, and should use other auxiliary materials or wood to assist in the retrieval.

4. When the woodworker pushes the table saw, he must put the wooden board close to the backing, and can't move it at will.

5. The woodworker should adjust the cutting speed appropriately according to the actual thickness and hardness of the board. During construction, it must be pushed forward at a uniform speed, not too fast or too hard.

6. After the woodworking table saw is finished, you must remember to turn off the power, and you also need to clean the saw table and the surrounding environment.

The above is a detailed introduction on how to bevel the woodworking table saw 45 and what you need to pay attention to when the woodworking table saw is pushed. I hope it can help friends in need. When carrying out woodworking table saw construction, it must be carried out according to professional construction steps to avoid problems.

Hi,Calling me,if you want to buy our machine!

Why???

Because.... I am salesgirl,hahaha

Wish you a fresh day!Bye~

Kaise Ellen