Where Did The Glitch Come From

Reason 1: The up and down position of the laser beam focus generated by the laser cutting machine is deviated, resulting in energy not converging on the workpiece, and the workpiece is not fully vaporized, which increases the amount of slag produced and is not easy to blow off, which makes it easier to produce burrs. Solution: Adjust the position of the focus of the laser beam, and adjust it to the best state according to the offset position it produces. Reason 2: The output power of the laser cutting machine is not enough to effectively vaporize the metal, resulting in excessive slag and burrs. Solution: Check whether the laser cutting machine is working normally. If it is abnormal, it needs to be repaired and maintained in time; if it is normal, check whether the output value is correct. Reason 3: The cutting line speed of the laser cutting machine is too slow, which damages the surface quality of the cutting surface and produces burrs. Solution: Adjust and increase the cutting line speed in time to make it reach the normal value. Reason 4: The purity of the auxiliary gas of the laser cutting machine does not meet the required standards, which will also cause burrs on the workpiece. Solution: Replace the auxiliary gas with higher purity. Reason 5: The working time of the laser cutting machine is too long, which makes the equipment appear unstable, which will also lead to the generation of burrs. Solution: Turn off the laser cutting machine and restart it after a period of time so that it can be fully rested.

Hi,Calling me,if you want to buy our machine!

Why???

Because.... I am salesgirl,hahaha

Wish you a fresh day!Bye~

Kaise Ellen